Adverse Events Module
For researchers submitting trial data to ClinicalTrials.gov, the Adverse Events module is one of four mandatory results sections. It requires reporting in three primary categories: All-Cause Mortality: A table tracking all deaths that occurred during the study, regardless of cause. Serious Adverse Events (SAEs): A tabular summary of events resulting in death, life-threatening conditions, hospitalization, or significant disability. Other Adverse Events: A table for non-serious events that exceed a specific frequency threshold, such as 5% within any study arm.
Adverse Events Module path is as follows:
Study -> Results Section -> Adverse Events Module -> Event Groups
Study -> Results Section -> Adverse Events Module -> Serious Events
Study -> Results Section -> Adverse Events Module -> Other Events
Adverse Events Module
Event Groups
| Title | Description | Deaths # Affected | Deaths # At Risk | Serious # Affected | Serious # At Risk | Other # Affected | Other # At Risk | View |
|---|---|---|---|---|---|---|---|---|
| Control Group: no DuraDerm | The usual care of pin track sites will be followed as outlined belowAll pins and wire sites will be cleaned daily while hospitalized. Basic pin care will be performed once daily by hospital nursing staff prior to discharge. Following discharge from the hospital, the pin care protocol will be continued by research participant's caregiver. Research participants will be instructed to notify the Principal Investigator if they observe any signs or symptoms of infection. These include redness around pin site, discharge, tenderness in the soft tissue, loosening of the pin, nausea, vomiting, fever or chills. Research participants will be instructed that the approach to pin care should occur in a step-wise fashion. Step 1: Brush the pin sites with saline using an ordinary soft toothbrush or gauze with sterile gloves Step 2: If following Step 1, debris remains, use forceps (tweezers) to gently remove debris. | 0 | None | 0 | 6 | 0 | 6 | View |
| DuraDerm® Group | All pins and wire sites will be cleaned daily while hospitalized. Basic pin care will be performed once daily by hospital nursing staff prior to discharge. Step 1: Brush the pin sites with saline using an ordinary soft toothbrush or gauze with sterile gloves Step 2: If following Step 1, debris remains, use forceps (tweezers) to gently remove debris. Step 3: Apply DuraDerm® with Q-tip on clean dry wound around (extending approximately one inch around pin site) and on the pin. DuraDerm® will be applied daily while in the hospital and then at a minimum of at least three times a week until pin removal. | 0 | None | 0 | 7 | 0 | 7 | View |